...inthe distibutor but still will not start try the camshaft sensor, if it is bad you will have a hardtime starting engine. will shut off will driving, but if these sensors fail, there should be a ...
Question about Jeep Grand Cherokee
...starting to give out. p0340 is the cam shaft sensor, this will cause it to cut off while driving, hardtime starting, p0351 is the ignition coil A primary/secondary curcuit mal function. p1391 is ...
getting behind the rear spark splugs i have a 2001 dodge grandcaravan and i'm having a hardtime figuring out a a easier way to get behind the rear spark plugs (#1, 3, 5). haynes manual ask to remove ...
what type of transmission fluild do you use for a 2001 sunfire. Having a hardtime putting the car in reverse and then inti park It uses Dexron II or III (you can use either) If fluid is full, DON'T ...
Question about Cars & Trucks
83 scamp gt has a hardtime shifting into 1st, this is a 5 speed manual ****** Is the clutch ok? Are you using the correct lube in the transmission? Does the shift linkage have what feels like ...
Question about Cars & Trucks
i have a 97 chrysler sebring ith a 2.5 engine. It has a hardtime starting but when it does it runs fine . can you help Check to see if fuel pressure holds at motor, with key on & engine off Fuel ...
My odyssey is having a hardtime starting and when it startsi it shuts off on it's own. Does the nutral safety switch have something to do with it. i put a new egr valve, new plugs and problem still ...
...the tiny parklamp bulb, or if you found the beam bulb connectors burned or melted, or having hardtime with the low beam bulb, then you need to remove the whole beam assembly. But who knows,
...never failed again. if crank or camshaft sensor fails there will be no starts,shutoff while driving,hardtime starting but these should set a problem code. have vehicle scanned to see if you have any ...
3,525 questions posted
Usually answered in minutes!
3,350 Questions
3,279 Questions
2,899 Questions
2,715 Questions
2,521 Questions