2002 Jeep Grand Cherokee "cant stop hazard lights" Questions

cant find indicator relay on 03 clio indicators stop working while driving if car stopped they work again.i pressed hazard switch they did not work then they started again cant find relay it sounds ...

...hazard fuse still cant get them to work help There is a conector box on the left side of your steering wheel on the colum loosen it and check your wires I bet when you just loosen the block they will ...

...cant get my left and right turn signals to work. Probably the flasher, as I think you have a separate flasher for the turn signals under the dash above the brake pedal. It is probably next to the ...

...stop, they didnt so i shut the car off, they stayed on still, when i tried to start the car up again the engine wouldnt turn over, the radio says to enter a code after the battery was unplugged ...

cant find it It should be up under the dash, usually close around the steering column. The turn signal flasher and the hazard flasher may look the same. If you turn on the hazard lights, you should be

cant find the hazard flasher remove left kick panel drivers side the flasher can be there or under panel just below knee panel next to steering column you have two problems here always ck bulbs first'

...stop light switch but still not working brake lights. i looked into the trunk at most of the wires but didnt see anywhere where it could be cut or loose. any suggestions? this car has a brake light ...

cant start it for about 10-15 mins I have a 2001 Suzuki Ignis and I have a similar problem. When I start the engine 5 beeps are heard and the hazard lights turn off and on with each beep. Also after I

cant stop lights blinkin hazardd switch on steering column broke cantstop lights from blinking need to take colunm cover off to fix dont know how You don't need to remove the column off to replace the

...hazard lights were working intermitently. now they have stopped working completely, the multi function switch for the lights is working as i checked it with an ohm meter. the fuse is fine(first thing ...