2001 Jeep Cherokee "communication start" Questions

...start the odometer reads no bus whats my problem?? a bad crank or cam sensor can cause this as well as a bad computer...find a reputable dealer or garage to check it out for you Sounds like a BUS ...

99 jeep grand cherokee no start 4.0L no power to injectors no spark no communication with pcm Check the auto shut down (ASD) relay located in the power distribution box.

P1686 P1687 JEEP GRAND CHEROKE 1999 Those two codes refer to a problem of digital communication between the Powertrain Control Module and the Sentry Key Immobilizer Module (1686) and between the ...

...start. the engine will turn over. the voltage is good but it reads nothing on the gauge, neither will the fuel. after a few seconds the odometer will read "no bus" Hi, the no BUS is usually ...

...communication line (wire) between the modules is down. It could be shorted to ground or power externally or a module itself is pulling it down. The engine, transmission, antilock brake, airbag, ...

...start. if anybody has changed the car stereo... or added an Ipod adaptor to it.. where the harness plugs into the back of the radio... what do the letters mean.. DTC.. diagnostic trouble code DRB the ...

...start/crank; no communication with PCM but scanner will communicate with TCM and ABS module Battery fully charged and checked every fuse possible; that I'm aware of. Scanner won't ...

...communication but it does start It was running real good and went to the gas station got gas and it stopped running around with it for a while and got it started next day went back to went to went ...

...communication problems, it is not possible to communicate with the control module. Therefore it will only be possible to read off the fault if it is intermittent. Substitute value None. Possible ...

...start until communication is re-established. Diagnostic Aids Important: Do not clear DTCs unless directed by a diagnostic procedure. Clearing DTCs will also clear valuable Freeze Frame and Failure ...