Question about Isuzu Trooper
prime.could it have an oil port blocked?changed a lot of oil pumps never had one do this.Have not added any stp etc. mother sounded great before to much pressure problem,blowing seal out on oil filter
...prime the oil pump? The best way to prime the pump hoping that you havent ran the engine to long without oil pressure is to remove the oil gauge switch ORoil light switch on the engine and get a ...
Question about Nissan Cars & Trucks
...oil pump but the problem is the same. You have to prime the oil pump if not that the cam is not driving it witch 2 things can happen cam gear stripped or rod is broken most likely just needs to ...
prime the oil pump, if not you locked the oil pump up. when installing a new oil pump you must prime it with new oil. if your cam isn't turning it sounds like your cam broke or your timing chain broke
Question about Cars & Trucks
...bad runs drive. impeller bad. filters. or not primed. Fisher Minute Mount MM 1 or MM 2 plow i guess elect motor spins ok and oil is full so bad pump is sucks air or is not primed and is air
...Prime the oil pump with clean engine oil by filling either the inlet or outlet port with clean engine oil. Rotate the pump shaft to distribute the oil within the pump body. Install the pump and ...
...prime your fuel pump relay may be faulty. With extended cranking, the oil pressures builds up and then the oil pressure switch will energize the pump. When the car has not sat long there is still ...
Question about Cars & Trucks
prime 3 second normal Ran fine for 2 days. Not now. Car has 50k original miles. Oil sensor has only one wire to it. Design change or??? Help! Did you check the inertia switch? In the trunk on the left
Question about Isuzu Trooper
...prime, and no start. could it be the crankshaft position sensor? No, it is more likely the fuel pump relay is at fault. You can check the pump itself by locating the lug on the firewall that ...
...prime the pump with engine oil. Pour oil in the exstension shaft while turning the pump. 6. Attach the pump, extension shaft and retainer to the main bearing cap. (aling the pump with the dowel pins ...
462 questions posted
Usually answered in minutes!
480 Questions
463 Questions
423 Questions
317 Questions
281 Questions