...throttle position sensor Removal & Installation Remove the idle air control (IAC) electrical connector (1) from the IAC sensor (4). Remove the manifold absolute pressure (MAP) sensor electrical ...
How do i install a Throttle position sensor on a 98 GMC JIMMY. located on side of throttle body
...throttle position sensor, but that didn't help. put a fuel pressure gauge on it and check cold and hot pressures if you have too take off hood and drive with gauge installed so you can see it. duct ...
...are the following: (1) Faulty Cam Position Sensor (2) Faulty Crank Position Sensor (3) Faulty Throttle Position Sensor ...any of them should show up in the computer fault codes though. Best
...throttle linkage and bracket. STEP 6 Disconnect cruise control cable. STEP 7 Remove brake booster vacuum hose at manifold. STEP 8 Remove PCV hose. STEP 9 Remove ignition coil and bracket. STEP ...
...position sensor, but i connected it and still have the problem. When i shift into gear the car idles down to about 1000. I tried unhooking and re-connecting the battery. The car wanted to start ...
...position aside with the lines intact. Disconnect the lower radiator hose, then disconnect the oil cooler and overflow lines from the radiator. Plug the cooler line openings to prevent system ...
...throttle position sensor on a 2004 changing throttle position sensor on a 2004 taurus Removal & InstallationDisconnect the negative battery cable. Disconnect the throttle position (TP) sensor ...
throttle position switch. how much for the part? is it easy to repllace? This sensor sends the ECU an output signal which corresponds to the opening of the throttle valve. Using this output signal, ...
...Throttle Position Sensor (TPS) is mounted on the throttle body and is connected to the throttle blade.The TPS is a 3wire variable resistor that provides the Powertrain Control Module (PCM) with an ...
1,950 questions posted
Usually answered in minutes!
1,123 Questions
1,127 Questions
1,104 Questions
838 Questions
768 Questions