2000 GMC Jimmy "ring tp" Questions

...ring on to the TP sensor. Connect the TP Sensor electrical connector (2) to the TP sensor (3). Install the TP sensor (2) on to the throttle body (1). Tighten the TP sensor screws to 2.3 Nm (20 inch ...

TP sensor O-ring seal Installation Procedure Install the TP sensor O-ring seal (7) on the TP sensor (6). Install the TP sensor on the throttle body with the throttle valve in the closed position. Make

...ring on to the TP sensor. Connect the TP Sensor electrical connector (2) to the TP sensor (3). Install the TP sensor (2) on to the throttle body (1). Tighten the TP sensor screws ...

...ring on to the TP sensor. Connect the TP Sensor electrical connector (2) to the TP sensor (3). Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part ...

...tp lose power while i'm driving i don't know if is electrical because it kills all the power idle is rough or if i just neen to change fuel pump i have allready change fuel filters. you must drop the ...

...ring to intake manifold, this will cause an almost undetectable vacuum leak and rough idle. A rough idle after changing the fuel filter in your 2004 Cadillac could be caused by several things. Here ...

...it will only start and die. I have put new tp sensor and a temperature sensor nothing. we put new rings did head job so we know that it has good compression if have any clue would be nice to drive ...

is more likely that the lines are leaking or the compressor pump needs a service. Just a new set of rings in the unit. Good luck, hope it helps

...to unlock and pull upwards tp remove then pull complete assembly out to remove bulbs locking ring and bulb bulb is also index so put back in same way reassemble in reverse but connect the bulb ...

...TP sensor and the throttle switch are combined as part of an assembly. The switch signal turns ON only when the throttle is opened to the idle position or at Wide Open Throttle (WOT) acceleration. ...