...water to drain out. Also, please note that this may be covered under the emissions warranty on the vehicle. If your vehicle is out of bumper-to-bumper warranty, check if the emissions warranty is ...
...Water Pump I'm replacing the water pump on a 2000 GMC Jimmy, but unable to remove the fan. I took off the 4 bolts but still am unable to remove it properly. Here is a link that I hope will make your ...
...replace the throttle position sensor Removal & Installation Remove the idle air control (IAC) electrical connector (1) from the IAC sensor (4). Remove the manifold absolute pressure (MAP) sensor ...
...water pump and the coolant temp gauge however its ranging from half to 3/4 temperature. Is it possible that a sensor could be off? It could be a few things - stuck thermostat , bad sending unit , bad ...
...replace the brake fluid periodically. Brake fluid degrades over time as it gets dirty and absorbs water vapour. If the car has ABS brakes, this may be a design feature you can't do much about. Ask a ...
...Water may have collected in the AIR pump or the vent solenoid and frozen or corroded the pump. Correction Replace the AIR pump and install a new inlet hose and solenoid tube assembly using the ...
...replace 99with a88 crank Not likely. They have different pitch and rotation values and actually have different journal sizes. Just guessing that your talking about the 4.3 engine and your talking ...
Question about GMC Jimmy
...water up to the seats so i changed all my fluids,new gas tank,fuel pump and spider injector.Now it starts first click and will idle but it sounds like it only running on 4 cylinders,i think it is in ...
water pump replacement Disconnect the negative battery cable, then drain the engine cooling system. 2. Relieve the belt tension, then remove the drive belt. 3. Remove the upper fan shroud, then remove
1,949 questions posted
Usually answered in minutes!
1,123 Questions
1,127 Questions
1,104 Questions
838 Questions
768 Questions