1996 Nissan Maxima "replace drive belts 1990" Questions

...belts-crankshaft pulley went bad. Replaced all of these and then it started to rough idle (head gasket leak?) installed stop leak (ceramic) and it starts well one time then the next time it starts ...

...drive shaft to get the lower cover off. Thomas Epps [email protected] You need to remove the timing chain cover, and then remove the timing chain. Check this link for the step by step way to replace ...

...1990 geo prizm 1.6 l engine replaced timing belt and cant find timing marks Below is the master help link provided to go through belt routing diagram:---Timing belt, drive belt, serpentine belt, ...

...replace alternator belt.you need to loosen alternator upper and lower belt then push alternator forward to slip off drive belt.if you have the prizim GSI. you need to raise and support the vechicle ...

...replace serp belt on 1990 f150 straight 6 and bypass air condition pump do i just get belt for truck with no air 4.9 manual tran 4 wheel drive They make an AC bypass pulley that you can put in place ...

...1990 I don't know exactly the engine code but may be this 205 documents can help you. The alternator belt or ancillary belt need to be removed before you can proceed to cambelt. ancillary drive belt ...

...make sure the timing marks on the cams and crank are set properly. No but also replace t belt tension pulley seals waterpump and drive,belts it time 60-90 thousand miles they break at aboit 90000 ...

...1990 Geo Storm GSI? Does it have one? My car is overheating. It has a brand new radiator in it but it doesn't seem to be moving any fluid, there is no flow. it is on the front of the engine and yeas ...

...replace a serpentine belt? 1990 Buick century custom, 4-door It is quit easy just make sure you have the routing diagram there is usually a sticker under the hood. the belt tensioner has a cut out in ...

...replace the failing drive belt and make sure it is tensioned correctly the noise is from a slipping belt and the battery problem is because the alternator is not charging because of the drive belt ...