98 expedition 5.4l had code PO354. This code refer to an open primary coil winding, open wire, or bad PCM. Check primary winding with ohm meter should be from 0.5 to 1.5 ohms and about 2.5 ohms with a
...give you the misfire reading and the system to lean codes. Check the #2 coil for firing. i have a 98 expedition 4.6 v8 and i pu new plugs and wires and its still reading misfiring cylinder 2.now
my 98 ford expedition will run for 4minutes and kill and wont start for a few hours a mechani changed my fuel pump and filter but its doing the same thing, then he said it could be my coils or my ...
...98 expedition cylinders 3 and 8 but do not know which are 3 and 8 #1,2,3,4 are on the passenger side or right side when sitting in the vehicle,starting from the front of the engine towards the ...
...coil problems.... plugged cat? 98 expedition suddenly runs rough... seems the spark plug was suddenly forced out which damaged the ignition coil. this happened 3 times within the last 2 years ...
...98 Ford Expedetion 4.6. When it idles in park it does not misfire as much as when in drive in idle. Give it RPMs and the misfire goes away. you have an ignition coil going bad if the check engine ...
...98 expedition and I don't know how it is possible to reach some of these spark plugs. (the spark plugs are located above the valve covers and UNDER a "COP", which instead of a typical spark plug wire ...
98 ford expediton cylinder misfire after tune up i have replaced 3 coils and all plugs fuel filter air filter exc...what could be the problem...it ran perfect then it sat for 3 days and went to start ...
coil. first four threads looked stripped and the rest of the threads looked ok. hopefully just need to tap out hole. is their a way to re-tap with out removing head? if i have to remove head. should i
98 expedition coil pack firing order 1-3-7-2-6-5-4-8
2,750 questions posted
Usually answered in minutes!
2,188 Questions
1,627 Questions
1,696 Questions
1,161 Questions
1,048 Questions