...Sensor (AKA Neutral Safety Switch, Digital Transmission Range Sensor, etc.). The speed sensor is located under the van. You have to remove the Y pipe from the exhaust and the heat shield to access
transmission range (TR) sensor. the back-up lamp bulb(s) located in both rear lamp (13404) assemblies circuit wiring and circuit protection Circuit protection is provided to the transmission range (TR
Question about Ford Cars & Trucks
...transmission range sensor ,from there circuit 1093 feeds to the starter relay . Battery voltage on that circuit would energize the starter relay turning on the starter an spinning the engine over . ...
...range switch all do by law, so you can not drive over the kids in gear. again it is NOT hot trans for sure, not hot. ok? the bell housing metal and that poorly named transmission cooler in the main ...
transmission control module that range sensor is showing the vehicle is in park or neutral and no problems with the anti-theft system , then it will energize the starter motor relay . Do you know what
...Transmission Range Sensor (DTR) indicates a Neutral range pass-thru, an uncommanded shift is possible if remaining 4L pre-conditions are met. The pre-conditions besides transmission in Neutral range ...
...range. Pry the shift indicator bezel out of the console using a trim stick. Apply the parking brake and place the transfer case in neutral. Remove the parking brake trim insert. Remove the console ...
...range. Pry the shift indicator bezel out of the console using a triin stick. Apply the parking brake and place the transfer case in neutral. Remove the parking brake trim insert. Remove the console ...
transmission range sensor. they are badly located and not well sealed. As a result corosion... The starter solenoid wire ( red/ light blue ) runs throught the range sensor before reaching the ignition
2,745 questions posted
Usually answered in minutes!
1,335 Questions
1,118 Questions
957 Questions
841 Questions
627 Questions