...Axle Wheel Bearing Puller T83T-1225-A Axle Wheel Bearing Replacer T83T-1225-B Driver Handle T80T-4000-W Impact Slide Hammer T50T-100-A Removal Remove the axle shaft; refer to Axle Shaft in this ...
...axle on the right rear of a 1999 explorer? it has a leaking wheel seal. 1. Drain diff if it has a plug. 2. Remove rear cover 3. Undo cross pin bolt and slide the cross pin out of the carrier 4. Push ...
...axle wheel hub retainer until after the wheel and tire assembly are removed from the vehicle. Wheel bearing damage will occur if the wheel bearing is unloaded with the weight of the vehicle applied. ...
...axle tube with a jack stand. Remove the wheel tire assembly. If you have disk brakes remove the caliper assembly. If you have drum brakes on the rear remove the brake drum. Then remove the rear cover ...
...axle Most AWD/4WD front axles are removed by taking off wheel at that corner,disconnecting lower ball joint,removing big axle nut,swing spindle out to get the axle out of the sealed bearing,then pop ...
...axle seal out of a 1996 4 wheel drive explorer There is a clip on the end of the axle. Here are the steps to remove clip.1 remove inspection cover and drain.2 identify large pin separating side gears ...
Question about Ford Explorer
wheel bearings. Good Luck Yes the rear differential could be the cause if you have a limited slip rear axle. The clutches could be binding in the rear axle.This would be noticeable especially on turns
axle seals, if they leak the rear diff will run low on fluid and cause the bearings to make noise. if the seals are leaking the rear diff will have to come out and be inspectec for internal damge,last
wheel puller or some heavy equipment nearby. Some cars you have to release the axle from the rear, take off the cover and pull a slip pin out, then remove all the bolts holding the wheels, brakes, hub
3,523 questions posted
Usually answered in minutes!
2,998 Questions
2,248 Questions
2,302 Questions
1,513 Questions
1,369 Questions