...bleed screw on the slave cylinder. If you removed the little brass screw you broke it. I find there is no way to get out all the air unless the slave cylinder is held verticle with consant pressure ...
Question about Ford F-150
...slave cylinder is most likely going out. if you fix that you should change the Throwout Bearing Pressure Plate clutch , alway get the heavy duty package. and inspect the folk... that holds bearing , ...
...bleed all air out of system all the way to the slave cylinder,,, this will / should restore the system. also,, check to make sure there is not fluid dripping from under the truck when you press in on ...
...YOU WILL END UP REPLACING THE CLUTCH MASTER CYL BUT THIS TIME YOU NEED TO GAIN ACCESS TO THE SLAVE CYL AND APPLY PRESSURE TO IT HOLDING IT BACK WHILE SOMEONE PUMPS THE PEDAL AND YOU BLEED IT ...
...bleed the clutch hydraulic system. It sounds like you are familiar with the bleeding process, but just in case I will provide instructions. Always make sure to chock the wheels and put the parking ...
...full if empty refill and pump and bleed clutch lines check on tranny for fluid leak could be bad slave cylinder as for not starting could be the result of no clutch because theres a safety switch on ...
...bleed the hydraulic clutch,fluid container was dry when someone depressed the clutch. Now I have to puch clutch all the way in and reverse is nearly impossible because of the grinding. The bleeder ...
...slave and remove the cap and push and hold the pedal down once, if it allows fluid to flow threw the bleeder port let it bleed about a pint of fluid to completely rid system with air. Remove the hose ...
bleed the slave cylinder when you attach the hose.9Reconnect the exterior parts, which includes the exhaust pipe and the gearshift inside the cab.10Drive your F-150 slowly in a controlled environment.
1,474 questions posted
Usually answered in minutes!
2,636 Questions
1,214 Questions
1,298 Questions
1,160 Questions
1,038 Questions