Question about Nissan Sentra
...bleed my cooling system. So my question is, where is the cooling system bleeder valve located? If you have a blown head gasket, surely you will overheat because some hot combustion gases are entering ...
...bleed ports to release any trapped air, and fill the radiator to the neck. Wait until the level stops dropping and make sure bubbles don't continue to come up. If they do, you may have a blown head ...
the thermostat has opened up, and by then it would be too late and the engine will over-heat. Also, be sure to bleed the trapped air from the cooling system by using any bleeders in the cooling system
...bleed ports to release any trapped air, and fill the radiator to the neck. Wait until the level stops dropping and make sure bubbles don't continue to come up. If they do, you may have a blown head ...
Question about Nissan Sentra
bleed the air out of your radiator cooling system. The hot and cold blasts of air coming from first hot water followed by air. Read up on how to bleed air out of your radiator system. Some systems are
...bleed valve, and you still think air might be trapped in the engine, you could find a coolant temperature sensor or sender unit that is at or near the top of the coolant passages or areas of the ...
...bleed air out of system, if air is trapped in system it will not heat right! drain radiator and flush it good, but when refilling turn heater on high heat. then bleed air out when refilling system. ...
Question about Cars & Trucks
...air will bleed out of your cooling system. Keep your car on long enough to give the (trapped air) time to bleed out of your system.Let your car cool down. Once the car is cool, take off the radiator ...
...air bound, how can I bleed it out? Look for bleeder valves somewhere on the top of the cooling system. If you see any use them to remove trapped air. Start the engine and slowly turn the screw to ...
Question about Nissan Sentra
bleed, loosen slightly to release trapped air. Once air is relieved, only liquid will come out at this time the air bleeding is done. no bleeder valves.. you have to run the engine with heater on full
795 questions posted
Usually answered in minutes!
798 Questions
708 Questions
716 Questions
570 Questions
442 Questions