1999 Ford Mustang Cobra "truck starter 3 terminal" Questions

Ad

starter with 3 terminal, a pos, a lead, and one already fixed on the starter.... i connected the pos and 2 bolts..nothing happens, it clicks the solinoid.... my old starter only had a pos ternimal....

Ad

...3 Turn the tester on and choose the option for "full charging system test." This will test your battery, starter and alternator and provide the most accurate picture of the problem. Step 4 Follow the ...

Ad

...starter is bad. If there is no voltage, replace the wire. Step 3 Check the fuse in the fuse box under the hood on the left fender well. If it is good, check the relay by pulling it out and checking ...

Question about Ford Mustang

1 Answer

...starter solenoid first. Ensure the battery is good and holding the charge. 5 years old, time for a new one. 3 years old, need to have it check for CCA (Cold Cranking Amps) Ensure your alternator is ...

Question about Ford Mustang

1 Answer

...3 years. Recently, it fails to idle after I start the engine. The problem is intermittent. The engine will run fine as long as the accelerator pedal is partially depressed. If I let off the ...

...3 times this year. what could possibly be draining the batterie when it sits overnight. i replaced the altinator, disconected the radio. the car runs great when i'm driving it and when i go into the ...

...3 days of driving it has developed a surge when at idle. When throttle is advanced in rapid manor it almost dies. Not sure if there is a vacuum leak, it is certainly running rich...mixture screw or ...

...3.8 v-6 to fire, but we do have power to the coil pack. juscll, If you have spark at the coil pack, pull a plug wire off a plug; pull the plug out. Put the plug back on the wire, and set the end of ...

...3 starter mounting bolts. Remove starter from transmission bellhousing. To install: Position starter motor to transmission housing. Connect battery cable solenoid terminal wire harness connector to ...

starter cable from the "B" terminal. 3. Remove the connector from the "S" terminal.4. Remove the two starter bolts, then remove the starter. 5. Reverse the procedures to install the starter. Hope that

Not finding what you are looking for?
1999 Ford Mustang Cobra Logo

325 questions posted

Ask a Question

Usually answered in minutes!

Popular Products

1998 Ford Mustang
1998 Ford Mustang

706 Questions

2000 Ford Mustang
2000 Ford Mustang

694 Questions

2001 Ford Mustang
2001 Ford Mustang

653 Questions

1995 Ford Mustang
1995 Ford Mustang

589 Questions

2002 Ford Mustang
2002 Ford Mustang

617 Questions

Top Ford Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

xxxxxx xxx

Level 3 Expert

5117 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...