1989 Ford Tempo "replacing rear wheel seals" Questions

...wheel and tire from the rear axle. Access the seals: Locate the rear outer seals on the axle and remove any retaining clips that hold them in place. Remove the old seals: Use a seal puller or a ...

...rear wheel bearing (1225) and the inner wheel bearing oil seal at the same time. NOTE: If the wheel bearing oil seal is leaking, the axle housing vent may be plugged with foreign material. Using the ...

...replacing rear main seal, seal sit in the rear of the engine block, the transmission will have to be remove, and the fly wheel to get to the rear main seal.If you have never removed a engine or ...

rear wheel seal replace how to put on rear wheel seal on F-150 1996 You will have to remove the rear axle to perform this job The seal will be inside the diff housing and is held in place by the axle ...

...rear wheel bearing replacement what about it? conventional axle or limited slip? Get axle code off door sticker. SECTION 205-02: Rear Drive Axle/Differential - Ford 8.8-Inch Ring Gear 1998 ...

...replacing the rear axle lubricant, use Rear Axle Lubricant XY-90-QL (ESP-M2C154-A) or equivalent. Removal CAUTION: The rear brake anti-lock sensor must be removed before the axle shafts are removed. ...

...Rear Wheel Bearings: Serviceable Bearings, Or Nonserviceable, Sealed Bearings. When Sealed Bearings Fail, The Bolts Holding The Bearing And Hub To The Axel Or Control Arm Must Be Removed. When ...

...wheel off, Undo the brake caliper, remove rotor, (Cant remember if you have to remove the parking brake shoes or not) If so do that next, ( If equipped with rear ABS remove sensor from axle housing) ...

rear wheel well on 99 bravada after driving Could be a stuck parking brake or a leaking wheel seal letting gear oil onto brakes. look at inside of rear wheels, if you see wet oil on backing plates, it

...rear axel and the tire. What parts do I need to look into replacing? You should be ok replacing the outer seal but check for bearing play or fautly outer wheel bearing before you disassemble. If to ...