1984 Ford F 350 "turn idle probe" Questions

...idle must read less than 1 volt (.85)...As you slowly increase throttle meter must rise smoothly to 4 volts at open throttle...If voltage jumps or acts erratic the sensor is defective... #2 is the ...

Probe? I could be wrong, I know they 2.0 has issues with the idle control valve.. Anyway, if you want to try cleaning it, try this link... its to a Probe, but should be the same as yours... http://www

idle? Put you + lead on terminal 3 and - lead on terminal 1 turn ignition on and check voltage to be at approximately 5 volts. You can also back probe with it connected at center wire and ground probe

...turn the key on by mine does not. When I jumper F/P to GND it still does not run. Car starts and runs OK. Fuel pressure at idle is 32 psi (low end of acceptable range) and briefly jumps to 38-40 psi ...

...turn key on,probe volt.on1st and4th wire of sensor plug normal reading is4 to 5volts if ok,start car let run till norm. temp.probe wires again while car is idling,norm.reading is0.4 to 2volts,if any ...

Probe Wont Idle when warm. I recently ran into problems with my ford probe idling rough and occasionally dying when you would stop quickly the rpm would go down to around 80 or lower before going back

...turn signal flash alternately..also lights flicker as car idles sounds like a short in wire to tail light, remove tail light and check ground first, if still problem then use wire probe and traces ...

...probe oil pressure gauge shows low,but the dip stick shows its full,i put like five quart in it,the engine makes a tap,i was thiking it was the oil pump bad,but i drove it a few blocks and it stops. ...

...turn key to on...Meter must read at least 3 volts...If not MAP is defective... Using the same technique lets test the TPS...Three wire connector Green/Light Green...Orange/White and ...

...idle air control valve bad? pull the IAC out and make sure that there is nothing blocking it from the throttle body from cleaning it. while you have it out go ahead and clean the IAC. the only way ...