10-1/4" ext hsg M.T., 4 spd (Warner T-18), 4x2, 12" ext, cable drive speedo M.T., 4 spd (Warner T-18), 4x2, 12" ext, elec speedo M.T., 4 spd (Warner T-18), 4x2, 4" ext, cable drive speedo M.T., 4 spd
EXT SE? Hi Melissa I have this procedure for Pontiac, try it remotes you will be using on the vehicle. Once you program the remote. all previous remotes that were programmed will be erased from memory
...10. remove 3 phillips/hex screws along the bottom inside of door panel 11. on outside/rear edge of panel push the 2 center pins of each in about 1/8"-this allows the clip to be pulled out w/ pin ...
...take up to 30 seconds. 11. Repeat step 10 NOW for each additional remote. (Including any existing remotes). 12. Turn the ignition to the ON position to exit the programming mode. 13. Test
10) Briefly turn on headlights, check that the bulbs work, turn off headlights 11) Push housing back into place 12) Push sliding tabs down to secure the headlight housing Good luck and this is for the
502 questions posted
Usually answered in minutes!
907 Questions
705 Questions
546 Questions
442 Questions
465 Questions