Question about Ford Crown Victoria
Why won't 89 cRown Vic stay running unless key held forward Usually the problem is inside the lock switch. You should have power at the EEC relay and the coil with the switch in the on position.
Install: Position the wiper motor. Install bolts. Tighten to 10 Nm (89 in. lbs.). Connect wiper transmission linkage. Install clip. Install wiper motor cover. Install mounting and pivot shaft assembly
...89 inch lbs. (10Nm) using a crisscross pattern. Raise the fuel tank to its mounting position, install the strap using new mounting studs and torque the nuts to 26 foot lbs. (35 Nm). Connect the fuel ...
Question about Ford Crown Victoria
position. Find the gas tank electrical connector by the tank. Pull it apart, and on the harness side of the connector, locate the wire going to the sending unit. I don't know what color it is, but the
...89 inch lbs. (10Nm) using a crisscross pattern. Step 10 Raise the fuel tank to its mounting position, install the strap using new mounting studs and torque the nuts to 26 foot lbs. (35 Nm). Step 11 ...
Question about Ford Crown Victoria
89 dodge dakota egr problems? Cannot determine meaning of Code 34 My truck idles in park well, when I hit the gas lightly, it bogs, and looses power, then suddenly accelerates, then cycles back to low
...89 inch lbs using a crisscross pattern. If no torque wrench is available, tighten to a snug fit and stop. (H) Afterwards, raise the fuel tank enough to attach fuel lines and vapor lines indicated ...
...position sensor is bad or a module. Secondary Spark TestThis spark tester looks just like a spark plug, attach the clip to ground and crank the engine to check for spark This spark tester has an ...
position sensor 89 f150? can i fix this throttle position sensor 89 f150? can i fix this myself? what tools do i need?? You only need general tools. It is located beside the throttle body. It would be
Question about Toyota Cars & Trucks
...increasing the code is 89 What is 89 and how to fix it from your description it is either the accelerator position sensor or the throttle motor position sensor check the pedal sensor and wiring ...
250 questions posted
Usually answered in minutes!
454 Questions
486 Questions
323 Questions
297 Questions
294 Questions