...turn signal in my 1986 toyota pickup every 5-6 uses it blows the fuse and my blinkers, backup lights, gas gauge and temp gauge stop working. What is going on 1986 t0y0ta pick up horn fuse location ...
Question about Ford Ranger
...turn signals, wipers, radio all stopped working at the same time on 86 chrysler fifth ave first thing i noticed to go was the turn signals figured it was a fuse so i checked fuses under dash and they ...
turn key is no power to pump so not sure what else and tried another computer for truck by fuse panel and still no power so not sure what else to try and has spark to I would interrogate the fuel pump
...Working through the slot next to the turn signal switch mounting boss, use a thin screwdriver to release the lock cylinder. To install, insert the key in the new lock cylinder. Hold the sleeve and ...
...turn signals goes bad is the the problem,, about $150.oo....What a pain. Hope this helps. replace the fog light relay. to stop the multi switch from burning insidewhich is caused if you use the fog ...
...turn engine off. If the RED LED flashes 3 times for 1.5 seconds, check the Crankshaft Position Sensor. Check the harness continuity at CPS when the engine is stopped. Inspect the harness for dust and ...
...working. Test for spark at one of the coil packs. If you have no spark, your ASD relay is probably not getting a ground. Following the procedure outlined in the Haynes or Chilton's repair manual for ...
...turn over even with starting fluid. I replaced the fuel filter 3 months ago. I can hear the fuel pump engaging when the key is turned deadhead. Please help we got a lot of kids to get to school. I am ...
...signals, voltage reg, injectors) (SEE NOTE #4 BELOW)27 Injector circuit isn't switching when it's told to (TBI)OR (MPI) injector circuit #1 not switching rightOR (turbo) injector circuit #2 ...
303 questions posted
Usually answered in minutes!
642 Questions
645 Questions
573 Questions
562 Questions
558 Questions