1997 Nissan Maxima "stalls put" Questions

stalls when put in 'drive' My 1997 nissan maxima (160k miles) stalls as soon as I put it in 'drive'. It starts up just fine, however, if I leave it in neutral and rev the engine a bit(up to 2k rpm) it

drove through 2 feet of water in my 89 nissan maxima it did not stall until 3/4 of a mile distance. After stalling I was able to get the car to start, but it putt putted and cut off as if it was out ...

manual clutch not working effeciently If the car has a few miles on it, the clutch may be worn. To test this, put the gearbox in 3rd and let the clutch out slowly while pressing the brake hard. The ...

...put it in drive and accelerate pass 2200 rpms or 30mph it makes a roaring sound and stalls on me. it sounds like it has a vacuum leak somewhere. You may be hearing the air intake - could be a leak in ...

...stalls, the engine goes off. i tried it couple of times. i put my car in P, then i tried closing my window. when i close it the car tried to shake and when i remove its fine. i tried couple of times. ...

...stalls when put in gear. Idles ok but is a little shaky. same thing in neutral. Cant go in reverse or drive without dying. Typically this is due to a vacuum leak. (Yes, it could be tons of other ...

93 maxima stalls when put in gear idles fine improves when it warms up MAF sensor.

put the car in reverse 95% of the time it stalls.Hope someone can guide me further. Thank you. Tommy. could be the oxygen sensor manybe, or fuel pump same happened to me, have the mass air flow sensor

...put in gear or reverse it stalls. The trans is also slipping out of drive into nutral or smae with reverse it is a bit better if the overdrive light is on but it also isnt changing gears right ...

...put it in reverse it stalls Generally there is something wrong that makes the engine too weak for that resistance of putting it in gear. That could be a misfiring cylinder, an intake manifold leak or ...