1998 Ford Expedition "knock removal sensor" Questions

knock sensor issues more times than not have been caused by other problems. After you remove the intake manifold disconnect the knock sensor connectors. Remove the bolts and the two knock sensors then

...knock sensor I have a 98 expedition with a 4.6L and the knock sensor needs to be replaced. I know that the its a long project and its under the upper intake. Is there a way to replace it without ...

...it goes on and off i have checked the oil and its fine and the truck seems to be running fine not knocking sounds or anything..... what could be the problem it is the sensor it is either the oil ...

...knock sensor. 8 Remove the front bolts on the oil pan and the socket-head bolt--the latter requires an Allen wrench. Disconnect the heater hoses and then unbolt and pull out the heater outlet tube. 9 ...

...knock) when the engine is under load or the vehicle is at higher speeds. There may also be other symptoms. Causes A code P0401 most likely means one or more of the following has happened: * The DPFE ...

...knock sensor and PCM (powertrain control module). The engine relies on the ignition spark to be delivered to the combustion camber at the correct time. If the ignition spark stops or is delivered at ...

Knock sensor for 2007 Saturn outlook. I can't pass emissions test! Check engine light on ? What code ? There are many different (DTC'S) - diagnostic trouble codes that can set for knock sensors ! ...

...Removal & Installation2.8L & 2.9L EnginesTo Remove: Lift the vehicle high enough to gain access to the knock sensor (KS) through the left front wheelhouse. Remove the left front wheel and ...

...knock sensor for a 1992 toyota camry v6 le First, I would like to mention that most knock sensor codes are not caused by the knock sensors, but a mechanical problem with the engine. The knock sensors ...

...knock sensor on a 1997 Nissan Altima? Inspect/Test/Replace A defective knock sensor may cause engine detonation or reduced spark advance and fuel economy. When a knock sensor is removed and replaced, ...