1990 Ford Mustang "replace distributor ignition pickup" Questions

replace it, you will need to remove the distributor from the engine, remove the roll pin near the bottom of the stem, pull the drive gear off the stem, a few bolts at the top, and then the whole thing

...ignition control module, pickup coil, coil, cap, and rotor still nothing and the rotor turns DId you check your distributer out? Not the Cap but the main distributer itself. My 1983 mustang is doing ...

light should flash. If it does not than I old suspect the ignition module and would probably replace the pickup cl in the distributor for good measure. This was a fairly common symptom back in the day

distributor cap shroud (or elsewhere) so they do not swing around. Diagnostic Method Trigger Parameters - Engine cranking or running (signal coming from ignition reference sensor) - No signal from the

replace distributor cap and the ignitor but I dont get a spark at the sparkplugs.henrys check all efi and ign fuses first...then check pickup coil and ignition coil in distributor w/ ohm meter...since

...ignition module ,throtel position sensor coil dist.cap,and rotor.Thanks THERE IS A PICKUP COIL IN THE DISTRIBUTOR, IF YOU HAVEN'T CHECKED THAT, IT IS PROBABLY EASIER TO CHANGE THE DISTRIBUTOR THAN ...

...The module is easier to replace - but the pickup coil is a wear item and the most likely fault. You could replace the module first and see if it starts or just replace both while distributor is

...housing. Usually this is furnished with a new module kit. If you still don't get any spark, then the pickup coil is bad. It is necessary to remove the distributor to replace the pickup

...pickup 22r motor. No fire to distributor, I have power to coil but no power from coil to coil wire to distributor. coil, distributor modgual, altunator, all checked good. any ideas wall help. At the ...

...distributor and the ignition coil. I think the ignition coil can be replaced if it is faulty. But if the pickup coil is bad, the entire distributor may have to be replaced. A remanufactured one won't ...