1990 Ford Mustang "clean effects fault codes" Questions

...Clean and regrease any corroded connectors with dielectric grease and repair any shorts. Hall effect sensor failure - Check the two, flat 3 conductor cables coming out of the sensor. These often ...

...on. Car was outdoor during 1 year by earlier owner. I d'nt cnow was this defect before or not. I cleaned fusebox contacts and change fuses. No effect. The air bag is turned off for now You will ...

...effects, plugs, wires, distributor cap and rotor. checked fuses and fusable links(all fine), couldn't find any broken or loose connections in wiring/ harness. my return cable plug on charging ...

...fault is induced the code will set and the wiring should be repaired for an intermittent open or short to ground. Disconnect and reconnect the distributor connector and PCM connector and ensure they ...

...failing that low idle could be limp mode.it triggers when either a major sensor faults or more that 3-4.the ecu will need to be checked for fault codes and then a plan of repair will be more ...

...sloppy shop work as not reading the fault codes first to find the problem does take it to an accredited service center that has experience on your make of vehicle and have it done ...

...clean cmbustion chamber there is no effective way of cleaning a combustion chamber other than to remove the head and use wire brush or scraper. In reality after the use of leaded fuel was stopped the ...

...codes for a Nissan pathfinder 2001 i just replace some 02 sensors and a mass airflow sensor, my check engine lite is on what can i do about it Hello! Which O2 sensor did you change? P0138 and P0140 ...

...Fault Code 54SynopsisDescription:  No fuel injector sync pickup signal during engine rotation Power loss light:  On Limp-in mode:  Logic module will guess at injector ...

...effects that has on the codes, that resets the traction system and turns off ST. You can turn it back on by holding it in again for ten seconds. If noting at all happens, you can be pretty sure ...