2004 Dodge Ram 1500 "39 time marks crank gear" Questions

...39;s a good time to check the front crank pulley (some have the outer ring move on the rubber). Put a piece of flat steel across #1 cylinder with a bolt through the steel extending into the bore ...

...39;t know where the cam and crank marks line up the makes are on the inside of cam gears and on the bottom crank there is a mark on the crank gear but if you cant find the one on crank just take out ...

...the belt to the cam gear & crank gear & balance shaft if it has one with liquid paper. remove belt, transfer marks to new belt, refit new belt so all marks align & it can't be

...crank pully Will be a little befor the six o'clock position. The mark on the passenger side cam gear will be about the 11 o'clock position. The mark on the drivers side cam will be a little ...

marks one at 3 o'clock one at 7 o'clock one at 9 o'clock. the one at 7 should align up with a mark on the block. Some have a raised semicircle and you line up the 7 o'clock mark on the

...39;s a bit complicated. There are two timing chains and the marks depend on having chains with different colored links to line them all up. The crankshaft should be where the key way is at about the ...

...39;t find a chilton book to cover this year and make Automatic/manual?? Did a 1.8 recently year 2000I think manual shift.. Can shaft timing is marked on gear and back of coverI belive Crank mark on ...

...39;t get the marks on cam and crank to line up. what you have to do is clean the chain very well you are looking for 2 links that are different colors than the rest (bronze colored ) count the links ...

...39;t no how to aline crank shaft up with the cams time Gear on crank has a dot stamped on it, gear for cam also has a dot stamped on it. when all is put together, the two dots must align with each ...

...39;s off, it will be facing 180 degrees off, then turn the crank one revolution.) If this doesnt jive, your distributor may be off a tooth. Also, ...are you sure the cam was positioned correctly? ...