1995 Dodge Ram 3500 "ignition switch replacement" Questions

...switch, condesor , replaced distributer , wires, plugs , coil is getting power to it at 13.3 volts I would suspect the ignition control if you have already replaced all that stuff. I personally would ...

...ignition switch check for burnt wires going into plug on switch very common on dodge trucks every thing runs threw the ignition switch and you can test the ac clutch with a jumper wire positive post ...

ignition switch. harness plug was bad so replaced with crimp on terminals DID THIS PROBLEM HAPPEN BEFORE YOU REPLACED THE SWITCH? IF IT DID, THAN SOUNDS LIKE YOU HAVE A BAD STARTER SHORTING INTERNALLY

...ignition switch..had a truck recently at dealership with similar problem and connector at back of ignition switch was melted..wires were for blower motor and battery feed to switch..had to replace ...

...to months. Strange. Any Ideas? Thanks, Scott. Your glow plugs may need to be replaced. check your ignition ...

...no sounds at all. no warning from starter motor. what could it be? Check the power wire to the starter while turning the ignition switch. If it is getting power replace the starter &

...Have already replaced swith, but did not help check for continuity across the switch wires. if nothing happens then you know you have a broken wire somewhere. make sure the ignition is to on. good ...

...ignition switch is suspect. If there is power going in and none coming out, the switch is bad. If there is power coming out, the problem is between the neutral switch and the relay. Step 5 Remove the ...

ignition switch sometimes not. Moving the gearshift lever has sometimes corrected the problem but that may just be chance. I'm wondering if it's the neutral start switch, and if so where is it located

...ignition switch? acts like it wants to fire when i wiggle ignition with key could be if the engine is not getting voltage from the ignition switch. take a test light and check for battery voltage at ...