2000 Dodge Ram 3500 "fix third brake light 1999" Questions

...the third one does no i have replaced the bulbs in it what else could be the problem all fuses are good DODGE RAM 1500 2500 3500 TRUCK SERVICE REPAIR MANUAL 1999 2000 2001... get your car fix right ...

...third brake light still works. I can't figure out to get the rear lights open to access the bulbs. changing the fuse hasn't fixed the problem. The whole assembly will pop out with a screwdriver ...

...third brake light comes on do not know way brake lights do not work. Also i have hitch but i disassemble hitch This is a well documented problem, replace the turn signal/multifunction switch to ...

Brake lights not working Not even the third eye? then the fuse is blown or all the bulbs are out or the brake light switch on the break pedal is bad wire off or broken( it breaks right off the plug ...

...third eye brake comes on and the right brake light goes out. I checked the wireing and it looks ok. any ideas? thanks I have a 2004 Jeep Grand Cherokee that I purchased only three months ago. It has ...

...third brake light housing; there are two or three screws holding it it in place. After taking those out and unplugging it, you can pull it out from the outside of the car. Note that the center brake ...

...third brake light works the other two go dead. during the day they(brakes?) work, but brakes are dim, with HL on, any help?? If the brake lights are to american system ?? then maybe a new switch .If ...

...fix once foundTools need test light with ground gator clipRock for pressing brake pedal down or second helper on brakesAnd a battery jumperMore than likely a wire pulled out harness on its back endI ...

...third brake light lighting up very dim. Also, the ABS light came back on. I also noticed that the cruise control is not working. All these issues are with the lights on. I turn the lights off and ...

...fix was to jump each side off the third brake light. I used the top bulb in assembly and disconnected the wire that feeds the brake light but left running light wire on. Havent had a problem