1995 Dodge Ram "distributor cap rotor" Questions

...distributor cap, and once the distributor cap is removed from the distributor, just remove the ignition rotor, and then simply un-plug the wire connector to the the pick-up coil/stator and then lift ...

...distributor has not sheared the shaft. Remove the cap and rotor, and make sure there is some tension on the shaft in rotation. If it does, using a voltmeter, check that power is reach the coil. Also ...

...distributor cap.) Using a good pair of insulated pliers. I want you to hold it about 1/4 inch from a good engine ground. Now you will need a bit of help from a partner. Get them to turn the key and ...

...distributor cap. It is a flat round plastic plate the cap pushes downn on when you put it on, with wires going to it. Disconnect the wire connector, remove the distributor cap, remove the rotor, pull ...

...ve changed the knock sensor, plugs, wires, distributor cap, rotor cap, coil, I have even checked the fuses. What else is there? Please help! Kirby Distributor Ignition Pickup. starter switch , ...

...module can be bought at any local parts store such as Autozone or Advanced Auto Parts. It is fairly simple to change. Just remove your distributor cap, Take of the rotor and you will see the pick

cylinder 1 3 5 7 not firing check both your distributor cap and your rotor arm may need cleaned.

...afterwards when I'm plowing the truck will stall/ shut down and then it won't restart. Now it starts and quickly shuts down. replace distributor , cap, rotor and timing reset. Check for impact ...

cap. If way off, the distributor needs to be removed and turn the shaft until the rotor points correctly when the unit is reinstalled. Final adjustment is then accomplished by rotating the body of the

cap on the distributor, at top dead center on #1 the rotor in the distributor should be at #1when the diistributor is all the way in and down in hole. then you should be close enough to time it with a