...intake manifold plenum extension. Tag and disconnect the secondary wires, then remove the retainer(s) from the distributor cap, and position aside. Unfasten the 2 coil cover attaching screws, then ...
Question about Chevrolet Corvette
...distributor which is sitting right under water pump,or the vacuum line that goes from it to intake manifold is plugged and not sucking moisture and some harmful gases that being crated inside ...
...Distributor & Water Pump . May I Have Bad Gas I Think I may Have gotten water in Tank Plus Its Been sitting 10 Months & didn't Get Driven Much 36,0000 There's spark at plugs ...
Question about Chevrolet Corvette
...leaking carb allowing fuel to run into the intake after shut down. have you checked to see if your missing spark when this happens. if not check if it could be a distributor component problem or
...distributor cop & coil Is it not turning over? injectors opening? fuel pressure low? Fuel leak? Blown fuses? Blown relay? Alarm starter kill switch? Ignition switch? the oil pressure switch sends ...
...distributor or the intake manifold, remove the cap and turn the crank by hand (youll need to pull all the spark plug wires) until it reaches TDC (compression stroke for number one cylinder) at this ...
...intake plenum) If you can find someone who has a fuel pressure gauge and run the car with the gage attached. I you can reset the timing 2 to 4 degrees less and see if that helps. Check the wiring to ...
...distributor rotates like a clock (clockwise) and the numbers on the clock starting at #1 is 1-8-4-3-6-5-7-2.... this is the firing order in a clockwise direction 15.) take the next plug wire #8 and ...
...distributor cap and rotor. The cold start coil is working too. could the fuel pump cause this?? Two things come to mind,on your holley did you put fenalic spacer plate between the carb and the intake ...
257 questions posted
Usually answered in minutes!
178 Questions
181 Questions
156 Questions
142 Questions
137 Questions