...ignition coil in a 93 corvette REMOVAL & INSTALLATION Disconnect the negative battery cable. Remove the intake manifold plenum extension. Tag and disconnect the secondary wires, then remove the ...
ignition coil, and a faulty ignition module can cause any one of these systems to malfunction. That does sound like a malfunction with the ignition module inside of the distributor, and you can remove
Question about Chevrolet Corvette
...ignition system harness, coil, wiring, distributor ignition switch etc. new or rebuilt at restoration 10 years ago. Naturally afraid to use vehicle. Rick. one of the symptoms of a faulty coil is that ...
ignition on, there should be 12 volts across the primary side of the coil (the small connections). Do not attempt to measure the secondary side of the coil (the big connection on the top) it will blow
diagnosis procedures based upon which ignition system you have in your car. The problem sounds like (a) worn-out Distributor Cap/Rotor or (b) bad ignition coil or (c) bad ICM (Ignition Control Module)
Question about Chevrolet Corvette
...coil, ignition module, cap, rotor, plugs and wires... was running before tune up 1979 corvette motor was running and I did a tune up. I changed the plugs, wires, coil, ignition module distributor cap ...
coil, ignition coil, and ignition module have all been replaced. a new battery, new spark plugs, new distributor cap & rotor were installed. there is fire to the distributor but no fire going out.
coil,ignition module. I have replaced several switches for this problem. At the coil, when you turn the switch on, there should be power. There also should be power when trying to start the engine. If
...ignition coil module inside the cap the other wire/s tranfers power from power connection to coil. A hei or high energy ignition system uses the coil module to amplify the voltage from the standard ...
...ignition ever seen this happen before ? can you help me ? I have heard of this happening when the tach is wired to the coil incorrectly. Most (if not all) tachs call for the signal wire to be ...
257 questions posted
Usually answered in minutes!
178 Questions
181 Questions
156 Questions
142 Questions
137 Questions