1989 Chevrolet Corvette "wiring dimmer light switch" Questions

light is so dim. At night it is not very bright....hard to read. What is my problem.? When I start the car the panel comes on real bright then fades down to nothing.. I need help. there could be a bad

...dimmer switch from circuit and use a set of jumper wires and jump the circuit connector and see what happens .If light come on when switch is bypassed the switch was the culprit . If not then your ...

...dimmer switch assembly this is a dark green wire. If you have 12 volts replace the dimmer switch assembly, if not repair the dark green wire. Hope this is helpful to you. Sounds like u have a ground ...

...light work no fire to dimmer switch don't know what they are far. the wires coming from the column are for your brakes and blinkers. check fuses, i mean pull them out and inspect. on older cars ...

...Dimmer switch? /Burned bulbs?/ loose wire??? I don't know. Am I missing something or is everyone answering the wrong question?If I am reading this right you are having problems in your instrument ...

...dimmer knob either on the light switch a wheel type on the dash somewhere. The other thing is the fuse. Under the dash should be a fuse box. one the cover should be a diagram and marked on it should ...

dimmer switch, pull connection off back, on harness with test light and headlight switch activated, 1 of the leads should have power, if so, use ohm meter on dimmer to make sure it has reading between

...light/dimmer switch, bypassed fuse 2 to new switch, for tail lights. new wire to both rear tail lights. Bare two wires shorted from dimmer/light switch, because I still had dash lights. Want to take ...

...dimmer switch to see wiring. This is not necessarily your dimmer switch. Most manufacturers tie the dash lights to the tail lights so that it warns you in a visible way if your tail-lights are not ...

dimmer switch is Yellow. Then low beam is tan, and high beam is light green . be sure the yellow wire has 12v. then check the other wires, if no voltage, then connect yellow to the tan or lt green, if