2004 Chevrolet Silverado 2500HD "remove replace knock sensor chevy" Questions

Ad

Question about Chevrolet Silverado 2500HD

1 Answer

knock sensor location on 2002 chevy 6.0 gas engine Knock sensors located under the in-take, in-take will have to be remove to replace sensors.

Ad

Question about Chevrolet Silverado 2500HD

2 Answers

replace it You have two knock sensor's, both sit under the in-take magifold on top of the engine, you will have to remove injector rail and in-take. There are 2 knock sensors on these motors. They are

Ad

Question about Chevrolet Silverado 2500HD

4 Answers

...remove and replace. Thanks Plenty! Jaylr2 If you go here it will show you the tools needed as well as step by step directions if you have a 5.3 engine. www.youtube.com/watch?v=IOKFqzRILB4 2000 chevy ...

Question about Chevrolet Silverado 2500HD

2 Answers

...replace the knock sensor on a 4 cyl 2.4 L 1998 Chevy Malibu? The knock sensor is on the back side of the engine near the trans. It is round, with a 1 wire connector. You will have to get it from ...

Question about Chevrolet Silverado 2500HD

4 Answers

...remove the intake manifold, because both of them are located under it. it is best to replace both knock sensors at one time, and you will need an intake manifold gasket too. I have a 2001 Chevy ...

Question about Chevrolet Silverado 2500HD

1 Answer

knock sensor is bad on a 2005 Chevy suburban 5.3. I have a light on that two mechanics read and both said it's the knock sensor low circuit #2 usually the sensors (2) are good but the harness goes

...a 6.0 liter engine Thank you HAS TWO KNOCK SENSORS they are both under intake in valley of engine. remove intake and will see two black grommets they are under those best to replace both at same ...

Question about Chevrolet Silverado 2500HD

3 Answers

...Remove the plentum and you will see two. clean before removing. replace and then put a dam of silicon to divert the water. the reason most fail are because of exposure to water. Also, the rusty ...

Question about Chevrolet Silverado 2500HD

1 Answer

...replace the knock sensor on a 2005 chevy tahoe,and what exactly do you have to remove? ? The knock sensor should be on each side of the engine block. These are single wire connectors and require no ...

Question about Chevrolet Silverado 2500HD

1 Answer

...replace the knock sensor?Check the wire going to the sensor(knock).Look for a bare place hiting up against something ,grounding it out.Make sure the plug to knock sensor is good.And make sure it is ...

Not finding what you are looking for?
Cars & Trucks Logo

882 questions posted

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6988 Answers

john h

Level 3 Expert

29494 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...