Question about Chevrolet Silverado 2500HD
all my gauges stopped working fuel speed temp ect. truck runs fine bad ground on car body I think the plug came off from gauges. You can check this by removing all/whole gauges.
Question about Chevrolet Silverado 2500HD
How does someone install manual oil pressure gauge on 2006 chevy 2500 with 6.0L Vortex where the oil pressure sender unit is on the block install a "t" fitting . Place the electrical unit in one side ...
rpm gauge, speedometer, & other gauges completely erratic. 2003 Chevrolet 2500HD, Duramax engine, Allison Transmission. 4WD Crew Cab, Long Bed This model always this problem, usually after about ...
...A few months later the tach. did the same thing but now it works from time to time. Now the fuel gauge has jumped all the way around the gauge and is stuck in about the 6 oclock position. Any idea ...
...sending unit,about 5volts=dim test light,if you do now jump the two wires together and see if your gauge goes to full,if your gauge goes to full its not gauge or wires but only your new sending
silverado gauges stop start Battery drained. While driving gauges, lights, and radio die then start almost immediately. After a few seconds the process repeats. While idle the gauges, lights, and ...
Question about Chevrolet Silverado 2500HD
the heat gauge shows different readings every time you run the truck. The truck seems to run the proper temp. The heat gauge on the transmission would rise if there was a problem with heat as the ...
speedometer is not working.. stuck at 120 mph. replaced sensor.. still broken.. also oil gauge is broken.. Sounds like this could be your cluster. Try getting one from a wreckers unless you want to ...
oil pressure gauge is pegged out all the time doesnt matter if the key is on off or if the duramax is running. im out of ideas to check my grounds are good, my cluster is good, all fuses and wires as ...
Question about Chevrolet Silverado 2500HD
instrument panel cluster gauges and odometer has stopped working where is the fuse located for the instrument panel cluster I had all my analog instrument panel gauges stop working after they did the ...
1,273 questions posted
Usually answered in minutes!
241 Questions
48 Questions
21 Questions
5 Questions
4 Questions