IF YOU HAVE 4WD VECHICLE..DISCONNECT THE FRONT EXHAUST Y PIPE FROM THE ENGINE AND THE EXHAUST SYSTEM.YOU HAVE TO REMOVE OIL PAN SKID PLATE.AND THE LOWER CONTROL ARM CROSS MEMBER FROM BELOW THE OIL PAN
...control arm. Remove the WSS cable clip from the frame. Remove the WSS cable electrical connector. Remove the WSS mounting bolt. CAUTION Carefully remove the sensor by pulling it straight out of the ...
...control arm bushing i am trying to get instructions on replacing my upper control arm bushings on a 1985 chevy pu the a arms need to be removed, and the bushings pressed in and out , then you will ...
Question about Cars & Trucks
...trans cross member with a 2wd remove the shock and release the lower ball joint with a floor jack under the lower control arm to lower the arm slowly stand off to the side incase the spring flies ...
Question about Cars & Trucks
...remove the ball joint from the arm, and possible damage to the control arm can occur, The better process is to replace the control arm assembly. Make sure to have alignment performed after replacing ...
...control arm on 2000 chevy tracker Remove the ball joint nut. Use a hammer and hit the spindle where the ball joint goes threw it. It will release eventually. Remove the sway bar link and the bolts(2) ...
...control module mounted on the wiper motor, unplug the electrical connections and remove the TORX screws holding it to the motor. Assembly is the reverse of dis-assembly. If you have any trouble or ...
control arm. Remove the axle nut (4x4) remove the caliper and the rotor. remove the outer tie rod from the knuckle. Remove the upper and lower control arm nuts and remove knuckle from vehicle. Using a
Question about Chevrolet Cars & Trucks
...control arm bushing installation I removed the lower control arm on the front of the vehicle, and also removed the rear bushing on the control arm. How do I reinstall the new bushing? The new bushing ...
...remove the drivers side door panel on a 94 chevy silverado pickup with manual windows? unscrew the inside handle and pop of the window arm....then slowly work your way around the panel poping loose ...
950 questions posted
Usually answered in minutes!
469 Questions
461 Questions
355 Questions
338 Questions
292 Questions