1997 Chevrolet Tahoe "replacing blower motor chevy" Questions

replacing my fan blower switch on my 99 chevy tahoe replace the blower motor, it is drawing to much current and burning up the switches The blower motor is burning the switch up,it is drawing too many

...blower motor resistor.It is on the passengers side by the blower motor under the dash.The resistor is connected to the blower motor and controls the blower speeds.They are known for going bad.Also ...

...blower motor and inspect could have leaf's or something in it, also check blower motor shaft make sure blower shaft bearing are good. The bushings on the motor is worn or the lubrication has run dry, ...

blower motor resistor. It's located under the dash on the passenger side of the vehicle just behind the blower motor itself. It's a fairly easy job to do. Just replaced one on my own truck. Good luck

...blower motor resistor & the resistor module connector (Pig tail). Call dealership and you can get the part give them the TSB Number Should take about 30minute to replace not to hard. Let me ...

...blower motor. worked fine for a few days and now nothing. all fuses are good. replaced resistor relay today. all ground starps are good but all i get is a clicking at the resistor. so i replaced it ...

...blower motors aren't hard to replace but the prices vary alot based on type. I had the same problem and my Tahoe almost caught fire. It did not blow a fuse when the speed control finally when out, so ...

...blower motor works fine , heater hoses are hot in an out of heater core. but can not get heat to dash at all, no defost or floor or middle. i think the problem is the actator. does anyone know the ...

...blower motor resister is bad...It is very common in chevy trucks. The resister is located behind the glove box and is held in place by two screws, it will also have a wire harness attached to it. If ...

...blower motor resistor in the front and got the fan speeds to work for the front dial but the rear dial still does not work. Any suggestions would be greatly appreciated. I DO set the front dial (next ...