1997 Chevrolet C1500 "sensor" Questions

location of crank sensor Crankshaft Position Sensor Removal & Installation 4.3L, 5.0L, 5.7L and 7.4L To Remove: Disconnect battery negative cable. Disconnect the crankshaft position (CKP) sensor ...

need to know wish is bank1 sensor and bank 2 sensor the bank one sensor is the sensor is in the bank of cylinder on the drivers side of the engine this is the cylinder bankl that has cylinder #1 in it

what does the 44 code mean on a 95 gmc 5.7 tbi truck Code 44 oxygen sensor detecting lean exhaust HI. This is an indication of a lean mixture as indicated by the oxygen sensor readings. 44 Code The ...

how to replace cam sensor This unit is part of the distributor. OPERATION See Figure 1 The ECM uses the camshaft signal to determine the position of the No. 1 cylinder piston during its power stroke. ...

flashing code 15,54,83 Fault Code 15SynopsisDescription:  No speed/distance sensor signal Power loss light:  Off Limp-in mode:  None  Possible CausesBad connector or

location crankshaft sensor 96c1500 5.7ci CRANKSHAFT POSITION SENSOR LOCATED NEXT TO THE STARTER. the crankshaft sensor is located on the bottom of the timing cover, this is where the bottom pulley for

1989 K1500 GETTING CODE 43 NEW ENGINE REPLACED KNOCK SENSOR AND THE CONTROL MODULE. The 43 is the knock sensor, the wires must be broken or fused together to continue to get the same code. Testing the

knock sensor question 2002 Chevy 1500: is the knock sensor under the intake mani? if so how do i remove intake mani? knock sensor is on the passenger side of engine block, some knock sensors fit into ...

...it's going to start but doesn't. Could it be the wiring harness on top of the coil pack, or map sensor or pick up coil. Any ideas?? (we live in Vegas so it's not freezing or anything..) I've ...

ruff idle when cold runs smooth when warmed up getting bad mpg was told could be idle speed sensor replaced mass air flo sensor egr valve and all o2 sensors diasonitic codes come up as running to rich