...crank but never start. It's located underneath the black plastic manifold on the side of the injectors. Try removing hose from throttle body and pour some fuel in engine if it fires up check for ...
...start while cranking acts like it is out of time pops out intake hook up scan tool and vehicle has no codes have replaced crank sensor already never know when it will do this sernario did it about a ...
spinning will not crank I have a 1995 gmc sierra It just spins over will not crank i changed plugs,wires,coil,cap and rotor,distributor module sometimes when it starts it cranks right up for a day and
It cranks but doent start Its a 95 gmc sierra 305ci manual trans It cranks but doent start I repaced the coil, cap, and rotore but still dont get spark, fuel pump works. ignitioin module inside the ...
crank but wont start i changed my fuel injectors, plugs, wires, dist. cap, rebuilt the tbi, ran for a lil while then bolted it back together and then nothing. it cranked and then no start wtf! i dunno
Question about Chevrolet C1500
start it but didn I have installed a new distributor and lost the right crank position. I cranked the engine to TDC but after replacing the distributor back in facing the #1 cylinder I attempted to
Question about Chevrolet C1500
1998 c1500 cranks but no start. No codes, good fuel pressure and spark. cranks but won't start. Fuel pressure is good, spark is good and no codes are stored in PCM. Cap, rotor and wires have 10k miles
engine cranks but won't start cranks but won't start Check for spark. Check for injector spray.
...start / the timing chain on the 4.3 is on the front of the engine. you will need to remove the water pump and the crank pulley to access the timing chain cover. You can see the cover if you look ...
376 questions posted
Usually answered in minutes!
584 Questions
420 Questions
403 Questions
331 Questions
284 Questions