1996 Chevrolet Blazer "wire continuity tester" Questions

Ad

...continuity tester to check the wiring from the switch to the brake lights Actuate the brake light switch separately (by hand) while someone watches the lights. Adriana, the male connector that goes ...

Ad

...Continuity tester with a light and a Multimeter also some wire and clamps, I don't know much about cars but if you could tell me where the horn is exactly, and where the relay is and how to ...

Ad

...wire in circuit or the drivers control unit is not working. NEXT... disconnect drivers door control unit and check to see which brass terminals have power (key on position), note them... then put 12 ...

...to verify that it is not routed too close to the following components: - The secondary ignition wires or coils - Any solenoids - Any relays - Any motors A low minimum air rate through the sensor ...

Question about Chevrolet Blazer

3 Answers

...the airbag by taking out the torx bolts on the back side of the steering wheel. Disconnect the wires for the airbag and horn. Remove the steering wheel retaining nut. Use any standard steering ...

...wire is not connected the fuse is bad. This applies to any of the fuses for your vehicle. That is the easiest way to find a bad fuse. Otherwise you will need to take a continuity tester (most ...

Question about Chevrolet Blazer

1 Answer

wire is to use a continuity tester. Put on tester lead on the frame of the tow bar and the other lead on a tow bar connector wire and you should get a light on the tester when you find the one that is

Question about Chevrolet Blazer

1 Answer

...You will need to investigate further to find the problem. Get a continuity tester and check for continuity to ground with each wire. I would suspect a door wire before the dome light wire. Good ...

...continuity tester. Just put the probes on each site of the fuse in the back of it while its plugged in. And if there isn't a beep out of the tester, that fuse is no good. Put the two probes of the ...

Question about Chevrolet Blazer

2 Answers

...wire. It would be best to have a multi-tester or multimeter. This should include a continuity tester and a voltmeter. With the use of the continuity tester you can put probes at both ends of the ...

Not finding what you are looking for?
1996 Chevrolet Blazer Logo

2,286 questions posted

Ask a Question

Usually answered in minutes!

Popular Products

Top Chevrolet Experts

Marvin
Marvin

Level 3 Expert

85178 Answers

Jonah Oneal

Level 3 Expert

14092 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22484 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...