...the hose runs through the wiper arm to a nozzle, if you remove the arms you can lift cover enough to look at the hose to washer connection,also check hose to arm they often break there good
...nut under the plastic cover at the end of the arm. (once nut is removed you may need a wiper puller to remove or carefully heat up the wiper arm with a propane tourch to break it free) hope this ...
Question about Chevrolet Caprice Classic
...Remove both wiper arms. Remove the plastic cowl cover below the windshield that covers from side to side. Once inside you will see the wiper motor/transmission assy. Disconnect the electrical ...
REMOVE WIPER ARM COVER AND NUT AT THE PUTSIDE OF THE LIFT GATE, THEN THE BEZEL, DONT SCRATCH PAINT ON THE LIFT GATE, REMOVE THE UPPER AND LOWER LIFTGATE INTERIOR TRIM PANELS, DISCONNECT THE ELECTRICAL
...wiper motor, first remove those little nut covers on the big end of the windshield wiper arms, if you slip a small screwdriver or your fingernail they just pop off. Now unbolt the windsheild wiper ...
wiper motor is under a component called the crank arm assembly.If you remove the plastic cover you will see a torx head screw.There is an arm coming from this metal part that is connected to the wiper
Question about Chevrolet Caprice Classic
...remove the wiper arms.Then remove the screws that hold the black plastic grill, you will see the motor.You will need then to disconnect the wiper arm transmission linkage from the motor, then remove ...
...covering it. remove that with a screwdriver by prying off gently. and loosen the nut almost all the way off. now wiggle the wiper arm back and forth and up and down.. you might need a screw driver to ...
...turn off replace the wiper board, go to your local chevy dealer and purchase the wiper board. remove the wiper motor cover & you'll see the wiper board. be careful not to break to the plastic
...wiper blades fit onto) down to the body. Normaly there is a little cosmetic cover that just clips over the bolt (its kinda round) Lift this cover up, sometimes you might need to wedge it with a screw ...
632 questions posted
Usually answered in minutes!
370 Questions
153 Questions