1992 Chevrolet C1500 "car front wanders" Questions

1992 chevrolet 4X4 Z71 with transfer case engaged right wheel spins and the left front wheel spins the other two wheels donot spin was wandering if anybody out there could help me thank you I believe ...

98 chevy pu, pulls slightly to right then it will correct itself and jerks to right, will wander on the road, replaced sensor on end of steering shaft. helped but did not correct. tires wearing very ...

While driving down the road my 88 chevy 1500 wants to swerve to the left and then to the right. I had the wheels balanced, and have put new shocks on the front. Any ideas? Check ball joints and tie ...

...end alignment". This is repairable, but good shops will not fix it until and unless the whole "front end of the car" is in good order. 3) A worn component in the "front end". God bless your

2003 accord front end shimmy and wander over 60 mph after installing 17" wheels and tires 2003 accord front end shimmy and wander over 60 mph after installing 17" wheels and tires Have the front ...

have a 1996 jeep grand cherokee zg model have a 1996 jeep grand cherokee zg model 180,000 kms loose/wandering steering... control arm bushes flogged out??...THANKS....S The Jeep has steering idlers ...

...wanders all over the road . what can the problem be yes the tire size is very important! however assuming everything is the correct equipment the wandering problem is likely the u-joints in the front ...

...noticed on straight aways. Car holds true through the turns. check tyre pressures on front two wheels,if problem persists get you two front wheels lined and balanced this will solve your ...

...it then drove it and diff was loud and axle popped back out.i installed used front diff and new axles,redrove and in 4x4hi it wanders bad and L axle popped back out. don't use 4wd on hard ...

...it seams to wander over road pulls slightly to left . its just had wheel alignment + front tyers, cars ks 236 thow , would new tie rod ends & shocks fix knocking & wandering problem? What was said ...