2001 Nissan Pathfinder "ground terminal locations" Questions

...ground or high in either the circuit or the sensor.Conditions for setting the DTC: * The Ignition is "ON". * The acceleration pedal angle is less than 2.5% or more than 97% for 12 counts within 500 ...

...replaced quite a few over the years. In fact, have several in my tool box that I use for testing. Ground the light green wire and try to start the truck. If it starts, then there is a break in the ...

...are three bolts, tensioner bolt on bottom two bolts on top, the two on top are tough, three wires ground, power, and harness, locate all bolts and wires loosen to take off. For clearance raise ...

...the ignition cable from the solenoid (this is the heavier cable) and put a multimeter from it to ground (somewhere metal on the chassis). Get someone to turn the key to ON and check for 12V at the ...

terminal 1. Ground is supplied to air control (rear window defogger switch) terminal 8 and rear window defogger timer terminal 4 through body grounds M14 and M68. With the rear window defogger switch

...ground is supplied: + to ASCD control unit terminal 9 + from ASCD steering switch terminal 4 + to ASCD steering switch terminal 5 + through body grounds M9, M25 and M87 then ASCD control unit holds ...

...terminal 3. Ground is supplied ? to front turn signal lamp LH terminal 2 ? through grounds E15 and E24, and ? to rear turn signal lamp LH terminal 5 ? through grounds B7 and B19. The BCM sends a ...

terminal will be connected to "ground", that being a bolt to the frame. (Often the alternator bracket) The positive wires go to switches, solenoids, and fuse panels. Power goes through those locations

terminal 1. Ground is supplied ? to headlamp RH terminal 2 ? to headlamp LH terminal 2 ? through grounds E15 and E24. With power and ground supplied, low beam headlamps illuminate. IPDM E/R - fuse box

...ground is supplied I to headlamp LH relay terminal 2 from smart entrance control unit terminal 21 I through smart entrance control unit terminal 22, I from lighting switch terminal 12, and I to ...