...skipping under strain thats why i had to change egr valve . seem to be running better but now want to cut off when in gear at idle . could it be idle sensor Check/replace the idle air control
idle control valve, it may not be working or dirty with carbon build up. Check the wire harness to the valve and try cleaning it with throttle body cleaner, do not use carb cleaner. You might get away
...idle under various load conditions such as AC turned on, heater, turning and braking etc. It's about a $50 part and 15 minutes-1/2 hr to change. where is the heater control valve located on a 99 ...
...Idle Air Control) valve, A O2 sensor or egr valve isnt going to have any effect on idle. It could be, but before you changing alot of parts, check all the vacuum lines, check them good. remove the ...
fluctuation in rpms,stalling at lights ,low idle. Just started 2 days ago have you changed the fuel filter I had the same problem, turned out i had to replace the idle control valve.
...It is held on by a couple of screws so it is very easy to change out. Good luck. Thanks for rating my response and for using
My 2003 Ford Expedition revs high when I go over 50mph. What's up? Change idle air control valve located at rear of engine.
...idle control was bad, replaced it. Changing spark plugs, not done yet. Air Filter, Fuel Filter,Plugs,Idles Solenoid or Valve, not the issue. Use logic and know what the parts your about to change do! ...
...change the spark plugs. I would recommend changing the plugs but also I would clean or replace the idle air control valve. This valve is located on the throttle body and is normally held on by a ...
Question about Ford Expedition
...fuel filter already Could be a dirty throttle body or a faulty idle air control valve.The computer controls the idle speed by regulating the air going into the throttle body thru the control
2,768 questions posted
Usually answered in minutes!
2,187 Questions
1,825 Questions
1,627 Questions
1,161 Questions
1,048 Questions