where is the cam shaft position sensor located on a 2001 gmc 5.7 , and also the crank position sensor? If this is a 5.7L the cam sensor is in the distributer and the crank sensor is in the timing ...
...crank shaft sensor and now the truck wont start why wont my truck start after replacing crank shaft sensor Probably defective or incorrect sensor, sensor wiring connector problem (bent or corroded ...
crank sensor isn't working properly, the engine doesn't know when do do anything. Depending on what the other codes where, I'd highly suspect the CPS. It's not terribly hard to get at nor expensive of
Question about GMC Jimmy
CRANK.SENSOR,DISTRIBUTOR,FIRE COMES AND GOES.DOES NOT HAVE A CONSTANT FIRE REPLACING the crank sensor requires a posible adjustment, this deals with your timing, sooooooo, sensor may need adjusted, re
crank versus cam sensor mismatch error and this leads to incorrect timing> This can be caused by an intermittent fault with either sensor. If the engine is sound mechanically I.e. the timing chains
...Crank Angle Sensor I need to replace the crank angle sensor on my 1997 GMC Jimmy. I can barely afford the part right now and would like to install it myself. Does anyone have or know of a link to a ...
Question about GMC Jimmy
...crank sensor and it ran for a day, Shut it off and would not start again, replaced sensor again and started. Then the same thing happened again. Now the crank sensor has no voltage supplied to it its ...
hold steady. Also you need to veryfy you have a signal coming from the crank sensor. Usually no-starts or hard starts on these vehicles will either be the fuel pump, injector assembly or crank sensor
...of the crank sensor in a 1991 buick Park Avenue this crank sensor can be seen from the front of the vehicle if your under the car laying on your back located behind the harmonic balancer ...
1,539 questions posted
Usually answered in minutes!
1,362 Questions
1,127 Questions
1,104 Questions
838 Questions
768 Questions