...transfer case,try in nuetral and at a stop, if still wont go then i would say the selector or switch is bad, remove the motor and see if it move when out of transfer case, also be fore removing test ...
Question about GMC Sierra
...transfer case make truck clunk My rear transfer case seal is going now my truck clunks when I put it in reverse could this be why No. The transfer case takes Dexron/Mercon 3. What was installed ...
Question about GMC Sierra
...transfer case is engaging and you can see the front drive line spinning, then you either have a bad actuator, switch, or the wiring is bad. I would recommend unplugging your actuator and checking for ...
...transfer case or the sensor on the front dif. Without further diagnostics, it could be any # of causes, but these are notorious for bad conections at the transfer case encoder motor and /or the ...
...transfer case. its the electric shift motor is worn out. I just changed mine. it is the black plastic tube that you see when looking at the bottom of the case. it is attached to an aluminum housing ...
Question about GMC Sierra
...transfer case encoder motor position sensor or the selector switch may fail causing the service 4WD message to be displayed. Fault code(s) stored in the transfer case control module will be of ...
...transfer case and using a 12v source check it on your own to see if that is what it is. You can also use an ohm meter on the conrtoller. If that checks out..try the Transfercase shift control modual. ...
Question about GMC Sierra
...transfer case acts like it wants to go in gear but pops out is it something they did when they rebuilt my ****** and put back together No. You have the electric select 4X4. The motor on the transfer ...
...transfer case has gone bad and needs to be rebuilt. if it is a newer style blazer (late 90's or newer) with the push button transfer case it could be the motor that shifts the transfer case is bad or ...
...transfer case (NP 241 C) and It still wont go into 4wd. The vacum line to the transfer case is capped off and always has been. the only thing left is the transfer case switch or the actuator. Can I ...
504 questions posted
Usually answered in minutes!
987 Questions
847 Questions
676 Questions
601 Questions
604 Questions