Question about GMC Sierra
...gear oil was used instead. That would not cause a clunk. It would cause a loss of fuel economy. When vehicles get old and the mileage ads up. Parts loosen up and/or wear out. Clunking in the drive ...
...gear mesh alignment when reassembling. Carefully remove the pinion flange from the pinion shaft. Use a bearing puller tool to remove the old pinion bearing from the pinion housing. Install a new ...
...install: Apply a light coating of gear lubricant on the lip of pinion seal. Install seal with Installer C-3972-A and Handle C-4171. Install pinion flange onto the pinion with Installer C-3718 and ...
...install: Apply a light coating of gear lubricant on the lip of pinion seal. Install seal with Installer C-3972-A and Handle C-4171. Install pinion flange onto the pinion with Installer C-3718 and ...
pinion gear(this is called in mecanic's word pre-load of your pinion gear)first witch is achievable by inserting shim washers and tightennig the pinion gear bolt. Then and only then you can adjust the
...Install an Nm (inch/pound) torque wrench on the nut and record the torque necessary to maintain rotation of the drive pinion gear through several revolutions. CAUTION: After removing the nut, discard ...
Question about GMC Sierra
...gear and pinion in my 1968 Camaro with a 12 bold rear end. It has 373 ratio now but the rear end code said it had 410 ratio. I want to change the ratio to 410. You can change the ratio back to 4.10. ...
...pinion gear. Sounds as if there is a shim missing, which will cause the pinion gear to hit the ring gear, causing noise, and considerable damage to both. Make sure the gears are all good. Another ...
remove/install the pumpkin with its bearings in place. If you're replacing the pinion gear, you'll need to take some painfully exact measurements or you'll NEVER get the ring/pinion clearances correct
...gear lube. Install oil seal using appropriate seal installer. Drive oil seal into axle housing until oil seal installer contacts axle housing. 2. Install pinion flange on pinion with reference mark ...
504 questions posted
Usually answered in minutes!
987 Questions
847 Questions
676 Questions
601 Questions
604 Questions