1989 GMC Sierra "gear oil put rear shaft" Questions

Ad

...oil or gear oil was used instead. That would not cause a clunk. It would cause a loss of fuel economy. When vehicles get old and the mileage ads up. Parts loosen up and/or wear out. Clunking in the ...

Ad

Question about GMC Sierra

5 Answers

drive vehicle. Check if any oil in diferential if not put gear oil in it.Don't know how to do your self have machanic check for you. After put oil in it and still grinding your diferential gear damage

Ad

gear oil. Then, you remove the pinion securing bolt. DO NOT ROTATE THE WHEELS AS THIS CAN CAUSE THE PINION GEARS TO FALL OUT. Push the rear axle shaft inward toward the vehicle and remove the "C" clip

Question about GMC Sierra

2 Answers

...80-90W positraction gear oil and add one bottle of friction modifier (Ford or aftermarket ok), fill to just below the plug (about one finger joint below) on side of center housing. That was

...gear oil for it of the recommended viscosity in the service manual. Generally thicker than motor oil. So, adding fluid would cost only the amount of the fluid plus some labor. A bottle of fluid might ...

...the gear oil from the differential cover and the axle. You can use RTV as a gasket if the OEM gasket is damaged. Fill the rear end with new gear oil of the proper type. Refer to your owner's

...gear tooth or metal in the differential oil.i`ve one were this was the problem(a broken gear) that would get caught and stop the forward motion or make it hard to turn.i`ve also had it were the rear ...

...gear oil in it. it changes gears good and runs good just makes noise in neutral noise goes away when i press in clutch. also if you jack up the rear end the wheels will start to spin in neutral.. the ...

Question about GMC Sierra

2 Answers

...oil out of the rear end and found a magnet in the bottom of the gear case and it had very little metal shavings on it it looked like just wear. I put it up on jacks and started it up and put it in ...

Question about GMC Sierra

2 Answers

...gear) To Install: Lubricate the lip of the axle shaft oil seal with grease. Install or connect the following: Differential side gears and clutch packs (vehicles with Ford 8.8 inch ring gear) Axle ...

Not finding what you are looking for?
Cars & Trucks Logo

504 questions posted

Ask a Question

Usually answered in minutes!

Popular Products

1998 GMC Sierra
1998 GMC Sierra

987 Questions

1997 GMC Sierra
1997 GMC Sierra

847 Questions

2000 GMC Sierra
2000 GMC Sierra

676 Questions

1999 GMC Sierra
1999 GMC Sierra

601 Questions

1994 GMC Sierra
1994 GMC Sierra

604 Questions

Top GMC Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6988 Answers

john h

Level 3 Expert

29494 Answers

Are you a GMC Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...