1995 Ford Taurus "idle control" Questions

Idle Air Control (IAC) Valve Removal Disconnect battery ground cable (14301). Refer to Section 14-01 . Disconnect the engine control sensor wiring (12A581) from the idle air control valve (IAC valve)

idle control where is the idle control valve located on my 1995 ford taurus. it is idle to fast The Idle control Valve will not in most cases help you check for a vacuum leak that csuses High Idle in ...

...The code is for the idle air control valve which controls idle speed. The problem could be a faulty control valve, or a vac leak which is letting in air to the intake and bypassing the control

...idle air control valve caused idle to go to 3800 rpm at a stoplight. Something seemed to give, has idled at 500 rpm since then. Replace the idle valve with a factory one and remove the negative ...

...Idle Air Control motor or throttle position sensor, or a big vacuum leak. Idle Air Control Valve Replacement Clean the throttle body and idle air control motor. Use a toothbrush and brake clean. Also ...

...Idle Air Control ValveIdle Air Control Valve Operation: A computer-controlled air bypass valve located in the throttle body. It helps control idle speeds by allowing air to bypass the throttle plates ...

...leak. Two look at the throttle body plate and idle air control motor. If the throttle body plate are dirty the seat for the idle air control motor my be dirty. I would try cleaning the throttle

...idle air control valve) causing the problem. There are many other possibilities causing these idle issues.Engine idles rough. There are few help links with solutions to troubleshoot such idle issues. ...

start up idle at 2000 when start it idles at 2000 Check your idle control sensor. or fuel control sensor. Possible vacuum hose loose.

...idle air control valve, sensor on the gas tank, spark plugs wire, coil pack, gas cap. Its my belief that its somewhere in the vacuum lines or air flow. Help!! Any suggestions. Its a great car besides ...