...connect the EGR tube to the new EGR valve, and finger tighten the EGR nut. Install the EGR valve to the engine with a new gasket. Install the two EGR valve mounting bolts, and torque to 15-22 ft lb ...
...Connect the EGR valve-to-exhaust manifold tube to the valve, then tighten the tube nut to 30 ft. lbs. (41 Nm). Connect all wiring or hoses to the EGR valve. Install the air inlet tube. Connect the ...
Question about Ford Crown Victoria
picture of your egr valve,located by firewall.Here's your iac. An EGR Valve is an Exhaust Gas Recirculation valve that is located on the intale manifold. Has vacuum line attached to top of it going to
picture HERE === Also remove carbon built up behind the EGR valve and the EGR passage tube. === Vacuum leak WILL offset the intended 14.7 to 1 air fuel ratio. More un-metered air (leaks) will lean out
picture HERE === Also remove carbon built up behind the EGR valve and the EGR passage tube. === Vacuum leak WILL offset the intended 14.7 to 1 air fuel ratio. More un-metered air (leaks) will lean out
...connect to power connector, now see if the egr valve opens, some of these are set up with power and ground already and the computer removes one to open the valve, so first try to test both connectors ...
...pre detenation please help me? Am I right or something missing ? Is my ECM have a short between the connection to egr selonoid to ECM ??? Hello, The EGR solenoid is activated by the ECM at mid range ...
Question about Ford Crown Victoria
egr to module. all ok. i was pulling my hair out cause this fault po401 always returned UNTIL i went to the throttle body and found the R port plugged, so i cleaned and po401,420 are gone, now i got a
Question about Ford Crown Victoria
...EGR Transducer vacuum line connect to near the firewall? Recieved code P0401. Visual inspection of EGR and Transducer revealed broken vacuum line in two places. Unable to trace vacuum line to intake ...
Question about Ford Crown Victoria
...connect to the steel EGR tube coming from the back of the engine to the EGR valve. (See picture of the sensor below)Another common failure is a DPFE sensor that has melted due to excessive exhaust ...
371 questions posted
Usually answered in minutes!
454 Questions
486 Questions
323 Questions
297 Questions
294 Questions