1983 Mazda RX-7 "air hydrolic clutch" Questions

Ad

Question about Mazda RX-7

1 Answer

...clutch master cylinder and slaves cylinder. About $70 at autozone. Make sure when you bleed it you get NO AIR not even little bubbles coming out of the bleeder. Bleeding the cluch is much more ...

Ad

...i press pedal all the way to the floor, even then it is hard to get into gear. Hydrolic clutch. What can be wrong? check that you have fluid in the master reservoir. Bleed air from the clutch

Ad

hydrolic clutch want to know a short cut? (trick) take the master cylinder for the clutch off the firewall and tilt forward while pumping the pistron by hand and bleeding those fords are notorious for

Question about Cars & Trucks

1 Answer

hydrolic clutch THERE IS A AIR VALVE ON THE CLUTCH HOUSING; OPEN ITT AND PUSH CLUTCH AND HOLD IT UNTIL THE AIR VALVE IS SHUT, REPEAT UNTIL THE AIR IS OUT. BUT MAKE SURE TO REFILL THE OIL SUPPLY AT THE

this problem happen before with previous vehicles. I found out the first time that i had air in the system. Then my pressure plate went on my clutch. Check for air in the hydraulic system and bleed it

Question about Mazda RX-7

1 Answer

...air from the hydrolic system of the clutch or it might be replacement of either the master cylinder, the slave cylinder and/or the fluid line that goes in between those two cylinders. Much good luck ...

...hydrolic clutch on a 1996 ford Ranger. Thank for you for your help First remove the clutch reservoir top. Make sure the rubber stopper/bladder is in the cap when removed. Next locate the clutch line ...

...hydrolic clutch for a 1999 ford ranger? you need 2 people one in cab and one down at clutch cylinder have one pump clutch and hold down ,and other person open bleed to let air out keep repeating this ...

...air control valve too.it is mounted on your throttle body.it controls airflow going to your intake. Hi ! The reason for unstable RPM is clutch plates... The honda clutch is operated by hydrolic ...

...air in the line and have to start over. this part should be located on the tranny this is for hydrolic bleeding system refure to your owners manual for your type and location of your clutchrelease ...

Not finding what you are looking for?
1983 Mazda RX-7 Logo

62 questions posted

Ask a Question

Usually answered in minutes!

Popular Products

1985 Mazda RX-7
1985 Mazda RX-7

-14 Questions

1988 Mazda RX-7
1988 Mazda RX-7

66 Questions

1987 Mazda RX-7
1987 Mazda RX-7

-18 Questions

1984 Mazda RX-7
1984 Mazda RX-7

-16 Questions

1990 Mazda RX-7
1990 Mazda RX-7

34 Questions

Top Mazda Experts

Marvin
Marvin

Level 3 Expert

85104 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22484 Answers

Jonah Oneal

Level 3 Expert

14092 Answers

Are you a Mazda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...