2004 GMC Envoy "rough idle stall condition" Questions

Ad

...rough due to weak fuel pressure. Its cheaper to replace, especially if it's still original from 04. Try running some injector cleaner through a couple of tanks of high octane gas. A common cause for ...

Ad

Question about GMC Envoy

1 Answer

...rough idle/stall condition in DRIVE gear only. When stopped at a light, it will start running rough, then stall. After very poor acceleration, it runs normal. This condition does not happen in Park, ...

Ad

Question about GMC Envoy

1 Answer

rough idle stalls at low rpm's Engine cranks fine, runs fine with choke, timing ok, rough idle, stalls at lights or stop hello first check your idle with the car running foot on brake see were your ...

Question about GMC Envoy

2 Answers

...rough idle condition. A dirty throttle body may cause a lower than normal engine idle resulting in a stalling condition. A stalling condition may also result if an idle learn procedure is not ...

...rough idle and then a idle fluctuation and a stalling problem. Another poss cause is the idle control motor is failing. This vehicle should be taken in for service at a very reputable repair shop. If ...

...idle rough and misfire at idle only Buck Run better when it's cooler outside and it also stalls when it has a rough idle Check for any sources of unmetered air entering the engine. ( Vacuum leaks ). ...

...cause the following conditions: • Rough idleStalling or slow idle speed • Oil leaks • Sludge in engine A leaking orifice may cause the following conditions: • Rough idleStalling • High idle ...

...can be reproduced with a spray bottle filled with soapy water. Spray the ignition components (wires, coils, distributor cap...)and look for the vehicle to idle rough. Replace any faulty

...WHEN IDLING?? BILL W.. no. Vacuum should only be applied under certain driving condition. No, vacuum applied to an EGR valve at idle will cause the valve to open causing a rough idle/stall ...

rough idle, stalls out, jumpy while idling at a stoplight. it tries to drive by itself Check the condition/operation of the PCV valve and associated vacuum/vent connections. Check for air leaks on the

Not finding what you are looking for?
2004 GMC Envoy Logo

3,345 questions posted

Ask a Question

Usually answered in minutes!

Popular Products

2003 GMC Envoy
2003 GMC Envoy

1,368 Questions

2002 GMC Envoy
2002 GMC Envoy

1,418 Questions

2006 GMC Envoy
2006 GMC Envoy

593 Questions

2005 GMC Envoy
2005 GMC Envoy

540 Questions

Top GMC Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

john h

Level 3 Expert

29494 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Are you a GMC Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...