2004 GMC Canyon "replace" Questions

where is the horn located under the hood of a 2005 gmc canyon Horn Replacement Removal Procedure Remove the grille. Refer to Grille Replacement .Disconnect the horn assembly electrical ...

...2004 GMC Canyon Crew Cab 4x4. I had a licence plate bulb burn out so I went and bought a couple to replace it with.I tried the lights out before replacing and noticed they were both out. I replaced ...

... works on highest speed blower motor might b going bad bearings inside  mine did same but when replaced it got all speeds back Here are some more common problems. Motor: The wiper motor is ...

Is my 2004 GMC Canyon turn signal flasher a replaceable part? "I need to know if my 2004 GMC Canyon (2-wd, 5-speed, 3.5L eng.) turn signal flasher is replaceable? I need to pull a trailer, and when I ...

ineed to replace a blower moter resister. only works on high setting The blower resistor pack needs to be replaced, it's common for the blower speed resistors to burn up and will need to be replaced. ...

2005 gmc canyon gets a little hot when at stop goes away when moving Replaced thermostat, checked water pump, replaced radiator, flushed fluid. Also replaced clutch fan. issue is that it keeps ...

I recently had my truck--a 2006 GMC Canyon inspected for brakes because there was a squealing noise occasionally when I applied brakes. I had it inspected and the technicians said that I should have ...

how do i replace the tail light bulb? to replace the GM tail light bulb, you will drop down the tail gate and you will notice 2 screws on the tail light assembly, you will remove those 2 screws with ...

how do i fix my car if my horn wont shut off i was replacing my stereo and now the horn when i apply power will not shut off unless fuse is pulled Disconnected horn button if horn stops need new ...

P0014 Diagnostic code, already replaced camshaft actuator & oil twice code p0014 - Chevy TrailBlazer, TrailBlazer SS and GMC Envoy Forum forums.trailvoy.com > ... > OEM Issues Sep 8, 2007 - 11 posts -